Take you to learn8Construction precautions for a soft film ceiling

The application of soft film ceiling has brought more colors to people's lives, and the material of soft film ceiling is also better than traditional ceiling. It has good waterproof and mold resistance, and is not easy to breed bacteria. During the construction process of soft film ceiling, some precautions need to be taken to ensure the characteristics and good decorative effect of the soft film ceiling. belowExtraordinary living layout diagramDesignerLet's introduce the construction precautions for soft film ceiling to netizens.

Soft film ceiling
　　1Before installing the soft film ceiling, you should first go to the construction site to see if there are conditions for installing the keel, mainly reflected in whether the wall body is completed, whether the carpentry is qualified, whether the plastering area is completed, and some dimensions of the carpentry must be done according to the requirements.

　　2Before installing the soft film ceiling, it is necessary to check whether the keel joint is firm and smooth. The sealing area should be properly treated and taped onto the sprinkler head. When installing the soft film ceiling, it is necessary to first fix it from the middle and both sides, and pay attention to the installation dimensions. The welding seam should be straight and the corner position should be well controlled. After finishing the final four weeks, trim off any excess ceiling to ensure a beautiful appearance.

　　3Open hole lamp: Mark the lamp hole and adjust it accordinglypvcThe light ring is accurately adhered to the bottom of the soft film. After firming, remove any excess lace.

　　4If conditions permit at the construction site of the soft film ceiling, carpentry should fix the parts according to the design drawingspvcSpecial keel, the corners must be flat and smooth at right angles.

　　5Open the air vent and light tube coil: Find the position of the air vent and light tube coil, and install the soft film on it, just like doing the surrounding workPVCOn the dedicated keel, make sure the corners are flat. After finishing, cut off the excess smallpox.

　　6Finally, clean the surface of the soft film ceiling with a clean towel.

　　7Pay attention to the lamp bracket, air outlet, and light tube panel being level with the surrounding keel, and ensure they are firm and stable without swinging.

　　8For smoke detection and ceiling lighting, first position it and then make a wooden base. The bottom of the wooden base should be polished smooth and pay attention to the horizontal height. If it is too low, it is easy to highlight the marks on the base.

The construction of soft film ceiling should be standardized and not careless. We also need to strictly control the quality of construction to prevent problems in future use. The above is a brief introduction by the editor on the precautions for the construction of soft film ceiling. I hope today's content can also be helpful to everyone!